Banpresto
Non Scale Gundam Head Display |
ZZ-GUNDAM
(Part6) |
| Did some test fitting with spare parts for the bottom of the neck. |
|
| |
| After some further fiddling around, eneded up with this configuration… Still feel like something’s missing. This will probably go through a few more iterations before I decide. |
|
| |
Having looked at some reference pics, decided it would look better for the side vents to ‘sit in a recessed cavity’ instead of being stuck onto the surface.
Held the part in place temporarily with blutack, and traced the outline using pencil. |
|
| |
| Cut away the hole so that the part would sit in nicely |
|
|
Test fit with a turbine part to simulate an air intake mechanism for the head. In the eventual configuration, hopefully the turbine will still be visible from both the front and side vents. |
|
|
Also, suddenly decided that the head cannon needs to be wider, so it was cut right in the center. Will be layering about maybe 3mm of pla-plate in between. The shape of the red piece needed some adjustments, as it used to sit inside a cavity on the forehead. Now it will need to rest on the outer surface. |
|
|
Clean up the parts again, and coated with surface to check for problems. Still a lot of surface problems which need to be fixed. |
 |
| |
|
|
| |
